Post-Processing Equipment
Wash & Cure
Form Wash L and Form Cure L stations for automated, consistent post-processing. Minimal hands-on time, maximum part quality.
Proper washing and curing is essential to achieving the full mechanical properties of any Formlabs resin. The Form Wash L and Form Cure L are purpose-built to automate this process — delivering repeatable results without manual handling or guesswork.
Equipment & Supplies
Form Wash L
Large-format automated IPA washing station for Form 4L prints. Agitates parts in isopropyl alcohol to remove uncured resin, then lifts the basket automatically to drain.
- Tank Capacity: 9.5 L IPA
- Build Platform Compatibility: Form 4L
- Wash Cycle: Programmable 1–60 min
- Dimensions: 44 × 38 × 44 cm
Form Cure L
Large-format UV curing station with integrated heat. Uniform 405 nm light exposure and programmable temperature up to 80°C ensures full polymerization of large parts.
- UV Wavelength: 405 nm
- Max Temperature: 80°C
- Build Volume: 40 × 33 × 32 cm
- Cure Time: Programmable 1–60 min
IPA Wash Solution (99%)
High-purity 99% isopropyl alcohol for use in Form Wash L. Removes uncured resin effectively without leaving residue that could affect surface finish.
- Purity: 99% IPA
- Volume: 4 L jug
- Compatible With: Form Wash L
- Disposal: Follow local regulations
Post-Processing Tips
Replace IPA regularly
Saturated IPA leaves a cloudy film on parts. Monitor resin concentration and replace when the solution turns dark orange.
Match cure time to resin
Each resin has a recommended cure time and temperature. Over-curing can cause brittleness; under-curing leaves parts tacky and weak.
Cure before support removal
For most engineering resins, curing before removing supports reduces the risk of deformation and breakage on fine features.
Need post-processing guidance?
We offer hands-on training for wash and cure workflows, including IPA management and resin-specific cure profiles.